Pci Card; Notes - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.11

PCI Card

This server provides PCI slots for riser card (one full-height PCI card and one low-profile PCI card), a slot for
LOM card, and a slot for RAID controller (total four PCI cards can be mounted).
1.11.1

Notes

Read the following notes when installing or removing a PCI card.
• Do not touch the terminals of the riser cards and the leads of electronic components with your bare hand.
Fingerprints and dust left on them cause the server to malfunction due to a connection failure or damage
to the leads.
• Available type of PCI card depends on riser card. Make sure the card type before connecting it to riser
card.
•
The server provides no connector to connect an LED connector which is supplied in RAID controller
used to indicate disk access.
•
PCI slot number "1A" is assigned to the RAID controller slot, "1B" is assigned to LOM card slot, "1C" is
assigned to the riser card for full-height PCI card, and "1D" is assigned to the riser card for low-profile
PCI card.
•
The search order for PCI bus slot on boot is as follows.
Slot 1A (for RAID controller) → Slot 1B (for LOM card) → Slot 1C (for full-height card) → Slot 1D (for
low-profile card)
•
The PCI devices of the same type (including onboard PCI device) may be recognized in different order
from those described above, depending on OS or RAID Configuration Utility. Check the slot location of
PCI device by PCI bus number, device number and function number shown in the table below.
LOM card LAN1 (when N8104-154F/155F/156F is
installed)
LOM card LAN2 (when N8104-154F/155F/156F is
installed)
LOM card LAN3 (when N8104-154F/156F is installed)
LOM card LAN4 (when N8104-154F/156F is installed)
Slot 1A dedicated for RAID Controller
PCIe slot 1C (Full height)
PCIe slot 1D (Low profile)
PCIe x16 slot 1C (Full height)
PCIe x16 slot 1D (Low profile)
•
If an additional LAN card is installed, it is hard to push the catch of the connector with your finger that is
connected to the LAN card. Disconnect the connector pushing the catch with a standard screwdriver. At
this time, be very careful for the screwdriver not to damage the LAN card.
Important
Avoid static electricity to work with the procedure below. For details, see
Chapter 1 (1.8 Anti-static Measures) in Safety Precautions and Regulatory
Notices.
PCI device
Express5800/R120g-1E User's Guide
Bus number Device number
05h 0
05h 0
05h 0
05h 0
01h 0
0Ch 0
40h 0
81h 0
C0h 0
1. Installing Internal Options
Function number
0
1
2
3
0
X
X
X
X
79