Table of Contents
Advertisement
RRU3942&RRU3642
Installation Guide
Figure 7-4 Moving the bolt out of the trough
Step 3 Slide the main and auxiliary brackets onto the pole and fit a bolt into the trough, as shown in
Figure
Figure 7-5 Sliding the main and auxiliary brackets onto the pole
Ensure that the arrows on the main bracket are pointing up.
Step 4 Use a 16 mm (0.63 in.) torque wrench to tighten the two M10 nuts to 40 N·m (354.03 lbf·in.) so
that the main and auxiliary brackets are tightly secured onto the pole, as shown in
Tighten the nuts on the two bolts alternatively. After the main and auxiliary brackets are secured
properly, measure the spacing between the brackets on both sides and ensure that the spacing is
the same on the two sides.
Issue 07 (2013-12-30)
7-5.
NOTICE
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Installing the RRU
Figure
7-6.
53
Advertisement
Table of Contents
