ABB Welcome M22311 Series User Manual page 42

ABB-Welcome
1. Attach a pair of supporting brackets to the back cover of the indoor station. Place 4
screws through the back cover and attach with 4 claw brackets.
attach
2. Rotate 4 claw brackets to to the supporting brackets and pull the rubber
bands around the corner of the claw brackets to fix the claws.
3. Put the back cover into the cavity wall
4. Tighten the screws
5. Latch the upper part of the indoor station onto the bottom part. Place the upper side
of the indoor station on the lock-in lugs and then press the bottom side onto the bottom
part of the device until it is caught by the clamp.
Replacing the front cover
The installation of the indoor station is now complete.
Pos : 94 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Steuermodul e - Onli ne-D okumentation (--> F ü r all e D okumente <--)/++++++++++++ Seitenumbruc h ++++++++++++ @ 9\mod_1268898668093_0.doc x @ 52149 @ @ 1
— 42 —
|