Yamaha Ego Avantiz Owner's Manual page 49

4. Remove the spark plug as shown,
with the spark plug wrench includ-
ed in the owner's tool kit.
ZAUN0643
1. Spark plug
To check the spark plug
1. Check that the porcelain insulator
around the center electrode of the
spark plug is a medium-to-light
tan (the ideal color when the vehi-
cle is ridden normally).
TIP
If the spark plug shows a distinctly dif-
ferent color, the engine could be oper-
ating improperly. Do not attempt to
diagnose such problems yourself. In-
stead, have a Yamaha dealer check
the vehicle.
Periodic maintenance and adjustment
2. Check the spark plug for electrode
erosion and excessive carbon or
other deposits, and replace it if
necessary.
1
Specified spark plug:
NGK/CR6HSA
3. Measure the spark plug gap with a
wire thickness gauge and, if nec-
essary, adjust the gap to specifi-
cation.
1. Spark plug gap
Spark plug gap:
0.6–0.7 mm (0.024–0.028 in)
7-10
To install the spark plug
1. Clean the surface of the spark
plug gasket and its mating sur-
face, and then wipe off any grime
from the spark plug threads.
2. Install the spark plug with the
spark plug wrench, and then tight-
en it to the specified torque.
Tightening torque:
Spark plug:
12.5 Nm (1.25 m·kgf, 9.0 ft·lbf)
TIP
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is 1/4–
1/2 turn past finger tight. However, the
spark plug should be tightened to the
specified torque as soon as possible.
3. Install the spark plug cap.
4. Install the panel.
7