Operation With Blades - Echo SRM-3020 Operator's Manual

OPERATION

Operation With Blades

Metal blades are very sharp and can cause severe injuries, even
if engine is off and blades are not moving. Avoid contact with
blades. Wear gloves to protect hands.
Blade use demands specific brush cutter configuration.
Operation without specified shield, barrier bar or U-handle, and
harness can result in serious personal injury. Follow installation
instructions.
Pro Maxi-Cut
Grass/Weed
Blade
Support
Handle, with or
without Barrier
Bar
Shield with
cutoff knife
Upper Plate &
Flat Washer
*ANSI standards require brush cutters be equipped with a barrier bar or
restrictive harness. U-Handle ensures a higher safety factor.
Do Not install blades on GT (Curved Shaft) model trimmers.
• Use only ECHO approved parts. Failure to use the correct parts can
cause the blade to fly off. Seriously injury to the operator and / or
bystanders can occur.
• Arbor diameter of upper blade plate must match arbor diameter of blades.
18
Tri-Cut Grass/
Weed Blade
U-Handle or Support Handle with
Barrier Bar
Shield without cutoff knife
Harness
Upper/Lower Blade Plates
Hex Nut
New Cotter Pin
Metal Grass /
Weed Blade
© 2/20 ECHO Incorporated
SRM-3020
Metal Brush /
Clearing
Blades
U-handle*
X7502350002