6.
Bundle and secure ignition leads against engine housing with clip
(G).
7.
Balance unit.
a. Loosen harness hook (H).
b. Put on harness and attach unit to harness.
c. Slide harness hook (H) up or down until unit balances with
cutting attachment approximately 2 - 3 in. from ground.
d. Tighten harness hook screw.
P
- O
RE
PERATION
OPERATION WITH BLADES
You must install a U-Handle/Metal Shield before operating this unit using metal blades, otherwise serious injury may
result.
Preparing the Trimmer/Brush Cutter for Blade Use
Blade use DEMANDS specific Brush Cutter configuration. Operation without specified shield and harness can result
in serious personal injury.
G
RASS
WARNING
DANGER
WARNING
DANGER
T
/B
RIMMER
RUSH
O
'
PERATOR
S
G
H
C
UTTER
15
M
ANUAL