Table of Contents
Advertisement
SRM-2620T
Operation of this equipment may create sparks that can start
fires around dry vegitation.This unit is equipped with a spark
arrestor to prevent discharge of hot particles from the
engine. Metal cutters can also create sparks if the cutter
strikes rocks, metal, or other hard objects. Contact local fire
authorities for laws or regulations regarding fire prevention
requirements
.
Operation With Blades
Blade use DEMANDS specific Brush Cutter configuration.
Operation without specified shield, barrier bar or U-handle, and
harness can result in serious personal injury. Follow installation
instructions.
PARTS REQUIRED FOR THESE BLADES:
Pro Maxi-Cut
Grass/Weed
Blade
Support Handle, w/or
w/o Barrier Bar
Shield w/cutoff knife
Harness
Upper Plate &
Flat Washer
Hex Nut
New Cotter Pin
DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL
TRIMMERS.
• Arbor Diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
X7502341000
© 1/2016 ECHO Inc.
Rigid Plastic
Tri-Cut
Grass/Weed Blade
U-Handle or Support
Handle
w/Barrier Bar
Shield w/cutoff knife
Harness
Upper Plate
& Glide Cup
Hex Nut
New Cotter Pin
OPERATION
Metal Blade
U-Handle or Support
Handle
w/Barrier Bar
Shield w/o cutoff knife
Harness
Upper/Lower
Blade Plates
Hex Nut
New Cotter Pin
21
Advertisement
Table of Contents
