Mira Vision Owner's Installation Manual page 28

Fit an isolating valve (not supplied)
close to the Digital Mixer Valve for
ease of maintenance.
Make sure that the outlet pipe work
protrudes approx. 60 mm through a
Dia 20 mm hole square to the finish
wall surface.
60mm
NOTE! To be trimmed after completion
of finished wall surface when installing
RAC.
Finish the surface of the wall as
required.
Trim the pipework back to the
required depth from the finished wall
surface. Remove all burrs and sharp
90°
edges.
Disassemble the right angle connector
assembly and mark the locations of
the screw fixings.
Drill the fixing holes. (7 mm diameter
for screws supplied.)
DO NOT drill through the backplate
into the wall.
DO NOT drill into buried cables or
pipes.
28
1184347-W2-G