4. Follow the procedure in
Intrusion switch
Removing intrusion switch
1. Follow the procedure in
2. Remove the:
a)
Side cover
b)
Front bezel
c)
Hard drive and optical drive module
d)
Heat sink and heat sink fan
3. To remove the intrusion switch:
a) Disconnect the intrusion switch cable from the connector on the system board [1].
b) Slide the intrusion switch and lift it away from the system [2].
Installing the intrusion switch
1. Insert the intrusion switch into the slot on the chassis [1].
2. Connect the intrusion switch cable to the system board [2].
46
Removing and Installing components
After working inside your
computer.
Before working inside your
computer.