Installation - Caple CR700 Instruction Manual

INSTALLATION

The appliance can only be used in recirculation mode only. In recirculation mode the
air and fumes conveyed by the appliance are cleaned by both a grease filter and an
active charcoal filter, and then re put into the air circulation.
At the beginning make sure that the package is intact and all the parts are
unbroken, otherwise stop the installation and contact the retailer. The manufacturer
is not responsible for damages caused by material handling or product installation.
Before installing the appliance read all these instructions carefully.
WARNING: This product is made of ceramic, for that reason it requires an
appropriate and accurate handling, as well as a professional and accurate
installation.
Remove the product from the packaging and lay it on a suitable place, a soft
material such as sponge or fabric should be used to place the product on it.
By using the supplied drilling jig, perforate the wall according to the four pattern
indicated by the jig itself. The center of the drilling jig should correspond to the
center of the hob. Insert the supplied dowel into the holes made, tighten them, but
do not tighten until they are flush; the three screws into the dowels corresponding
to the holes with discharge head (Fig.8 A) leaving the hole for the locking screw
empty (Fig. 9 B) because it will be added later.
Place the ceramic cover over the suctioning element and insert the steel cables into
the three holes of the ceramic, as shown in the figure (Fig. 1). Put the power cable
through the air outlet grill, see Figure 2 The ceramic part must perfectly cover the
metal part named "D" in the exploded view.
Remove from the packaging the ceramic cover for the ceiling plate (see the detail
B on the exploded view), place the cover over the hood and put the steel cables
through the three holes in the ceramic body, the power cable should be put
through the central hole of the ceramic, see Fig.3. Extract the metal plate from the
packaging and then put the steel cables through the appropriate supports,
as shown in figure 4.
Adjust the height of the product scrolling the steel cables up and down inside
the support, it is necessary to unscrew and push the support in order to allow the
scrolling of the cable, see fig. 5.
Please keep this instruction manual for future reference
7
Instruction manual CR700 / CR750
CR700_CR750_Instruction manual.indd 7 04/04/2018 14:08