Table of Contents
Advertisement
INSTALLATION
Prepare for the installation:
If you have an outlet to the outside, your cooker hood can be
connected as per the below picture by means of an extraction
duct with an interior diameter of 150mm.
Before installation, turn the unit off and unplug it from
the outlet.
The cooker hood should be placed at a minimum distance of
65~76cm above the hob. It is the manufacturer of the hob
who determines the clearance required and the clearance
quoted by the hob manufacturer must be followed. In the
absence of any instructions supplied with a gas hob the
minimum distance between the hob and the hood must be
at least 760mm.
4
4
4
Please keep this instruction manual for future reference
10
Instruction manual FSCHSS8
INSTALLATION – DUCTED
ATTENTION! OBSERVE THE WARNING CONCERNING THE OPERATION OF THE
APPLIANCE WHEN AIR IS DISCHARGED FROM THE ROOM.
INSTALLATION METHOD 1:
- To install onto the wall drill 2 holes of Ø8mm
in a suitable place according with the centre
distance of hole in the back of the cooker
hood.
- Insert the nut into the holes.
- Insert the screws into the nuts and tighten.
Put the cooker hood onto the tightened screws.
- Fix the cooker hood with the safety screws.
The two holes are positioned on the back
casing, with diameter of 6mm.
- Attach the one way valve to the cooker hood.
INSTALLATION METHOD 2:
- Drill 4 holes of 6mm diameter at the bottom of
the hanging cupboard
- Attach the one way valve to the cooker hood,
then install the cooker hood onto the bottom
of the cupboard, tighten the hood with the 4
screws supplied.
- Install the adjusted board on the bottom of the
hood in order to reduce the gap between the
back of the hood and cupboard
NOTE:
1.The ducting tube is not supplied with the extractor.
2.Take off the protective film before installation.
5
Please keep this instruction manual for future reference
Instruction manual FSCHSS8
11
6
Advertisement
Table of Contents
