Port Number; Connect Mode - Lantronix WiPort NR User Manual

Port Number

The Port No setting represents the source port number in TCP connections. It is the
number that identifies the channel for remote initiating connections. The port number
functions as the TCP/UDP source port number for outgoing packets. Packets sent to
the unit with this port number are received to this channel. The port number selected
is the Incoming TCP/UDP port and Outgoing TCP/UDP source port.
The current value is displayed in parentheses. The default setting for Port 1 is 10001.
The range is 1-65535, except for the following reserved port numbers:
Port Numbers
1 – 1024
9999
14000-14009
30704
30718
Note:
setting as incorrect operation may result.
Use Port 0 for the outgoing local port to change with each connection. The port range
is 50,000 to 59,999. Each subsequent connection increments the number by 1 (it
wraps back around to 50,000).
Only use this automatic port increment feature to initiate a connection using TCP. Set
the port to a non-zero value when the unit is in a passive mode or when using UDP
instead of TCP.

Connect Mode

Connect Mode defines the unit's connection method and its reaction to incoming
connections over the network. The current value is displayed in parentheses.
Enter Connect Mode options in hexadecimal notation:
Connect Mode Option
WiPort® NR Embedded Device Server User Guide
Table 5-6. Flow Control Options
Flow Control Option
No flow control
XON/XOFF flow control
Hardware handshake with RTS/CTS lines
XON/XOFF pass characters to host
Port No (10001) ? _
Table 5-7. Reserved Port Numbers
Reserved for
Reserved
Telnet setup
Reserved for Redirector
Reserved (77F0h)
Reserved (77FEh)
It is recommended to not use the reserved port numbers for this
ConnectMode (C0) ? _
Table 5-8. Connect Mode Options
5: Configuration via Serial Mode or Telnet Port
Hex
00
01
02
05
7 6 5 4 3 2 1 0
37