Table of Contents
Advertisement
8.7
Decommissioning the machine
NOTICE
Damage as a result of an extended period out of service
If the machine is going to be out of service for longer than six months, then take the necessary
measures for preservation and storing. Otherwise damage to the machine will result.
Record the decommissioning steps. This log will be useful upon recommissioning.
8.8
Re-commissioning the machine
When you re-commission the machine, proceed as follows:
● Study the record made when the machine was decommissioned, and reverse the measures
● Perform the measures listed in the "Commissioning" section.
8.9
Faults
8.9.1
Inspections in the event of faults
Natural disasters or unusual operating conditions, such as overloading or short circuit, are
faults that overload the machine electrically or mechanically.
Immediately perform an inspection after such faults.
Correct the cause of the fault as described in the respective remedial measures section. Repair
any damage to the machine.
8.9.2
Electrical faults
Note
If you are operating the motor with a converter, the operating instructions of the converter
must also be observed if electrical faults occur.
LOHER CHEMSTAR 1PS5
Operating Instructions 03/2014
that were taken for conservation and storage.
Operation
8.9 Faults
77
Advertisement
Table of Contents
