Adjusting Transitions; Changing Transition Speed; Changing Transition Direction - Videonics MXPro DV User Manual

70 MXP DV U G
RO SER UIDE
A T
DJUSTING RANSITIONS
Every transition runs at a pre-set speed and direction. Symbols appear below the
transition icon in the Transitions Menu indicating the current speed and direction.
Transition Speed
Use the
tion.
Transition Direction

Changing Transition Speed

Transition speed values can range from 0 (slowest) to 9 (fastest).
To change the transition's speed:
MXProDV changes the Transition Speed indicator below the transition icon to the
currently selected value. You can change the speed any time either prior to running
the transition, or while it runs (which allows you to make adjustments "on the fly.")

Changing Transition Direction

Transitions can run in two directions — forward and reverse. If you use the
ton, transitions run, by default, in the forward direction. If you use the
it up runs the transition forward; moving it down runs it in reverse. For example, a
simple wipe transition might move a vertical border across the screen from right-to-
left or left-to-right, replacing scene a with scene b.
Transition Icon
and
SPEED REVERSE
NOTE
When you change a transition's speed and/or direction, the change applies to all
other transitions until you specifically change it. For example, if you set the speed
of the current transition to 4, all subsequent transitions run at this same speed until
you again change the speed factor. This also applies to transition direction.
Press . Each press increases the speed by one unit. Press
SPEED
the speed by one unit.
TIP
To directly set the speed to a specific value, press and hold the
value from 0 to 9 on the numeric keypad.
Transition Direction
buttons to change the speed and/or direction of a transi-
REVERSE
Transition Speed
SPEED
C
HAPTER
+ to decrease
SHIFT SPEED
button while entering a
SPEED
PLAY
, moving
T-BAR
5
but-