Using Learn Mode - Videonics MXPro DV User Manual

132
MXP DV U G
RO SER UIDE
3
4
5
6
U L M
SING EARN
Learn mode involves the following steps:
1
2
3
4
5
You can also use a GPI trigger device to play the steps in a Learned Script. A GPI trig-
ger device works exactly the same as pressing
ning on page 152 for more information.
Press again to increase the transition speed one more unit (step three).
SPEED
Press once more to increase transition speed another unit (step four).
SPEED
Enter 55 to designate that transition (steps five and six).
It requires two steps to enter the two digits.
Press (step seven).
PLAY
TIP
Using keys to select a transition consumes one step for each key pressed. In most cases,
ARROW
to fit as many transitions as possible into a Learned Script, use the numeric keypad to enter
transition numbers rather than using the
Select the CURRENT and NEXT sources before entering LEARN mode. LEARN mode interprets
pressing the button as a transition.
CUT
ODE
Activate all devices.
Turn on MXProDV and all devices you intend to use, if necessary.
Press +< > to engage Learn mode, where <
LEARN NUMBER
from 1 to 8. The number designates the Learned Environment you want to use.
Note that the
INPUT EFFECTS
Enter production steps.
Create the production in the same way you would even if you weren't using Learn
mode.
Press again to disengage Learn Mode.
LEARN
Learn mode disengages automatically if you exceed 250 total steps, the maximum
allowed in all combined Learned Scripts.
Play back the Learned Script.
a Enter + +<
SHIFT LEARN
#> is the number of the Learned Environment and Learned Script you want to
play back. Remember, the Learned Environment/Learned Script numbers can
range from 1 through 8, inclusive.
When this step finishes, MXProDV restores the selected environment and the unit
is ready to play back any learned scripts.
b Press or use the
PLAY
, you can manually control any transition in the Learned Script.
T-BAR
CAUTION CAUTION
You cannot edit a Learned Script. The only way to change a Learned Script is to
reenter it from the beginning. If you recall a Learned Script and begin entering
commands, MXProDV OVERWRITES the previous script.
keys.
ARROW
LED (or, light) flashes while MXProDV is in Learn mode.
#> on the keyboard, where <
LEARNED SCRIPT
to run each step in a Learned Script. When you use the
T-BAR
PLAY
> can be any value
NUMBER
LEARNED SCRIPT
. See "Using a GPI Device" begin-
C 11
HAPTER