Using Other Effects With Single Pips - Videonics MXPro DV User Manual

106 MXP DV U G
RO SER UIDE
You can apply the following shapes to PIP tiles. To select a shape, press the numeric
key (0 through 9) that corresponds to the shape you want, as indicated below.
Manipulating the The mask changes shape, size, and position when you change the corresponding
Mask attribute of the foreground tile. You can, however, manipulate the mask indepen-
dently, as discussed in this section.
Table 12: Manipulating PIPs Mask

Using Other Effects with Single PIPs

Input Effects You can apply any of the input effects (see Chapter 6, Input Effects) to the background
and any except color correct to the foreground tile). Apply the input effect(s) you
want prior to entering PIP mode.
The Freeze Effect You can apply the Freeze effect (see "Freeze" on page 97) to the background and/or
foreground tile.
Press
the freeze effect.
Press
again to release the freeze effect.
When you exit PIPs mode, MXProDV removes the freeze effect from the foreground
source.
0
5
T
O
U
CHANGE SE OR PRESS
...
MASK
Position
+
SHIFT JOYSTICK
Style (Press keys repeatedly to cycle through available colors and styles.)
BORDER COLOR
BORDER STYLE
Size
+ -
SHIFT T BAR
+
SHIFT UP ARROW
+
SHIFT DOWN ARROW
+
SHIFT RIGHT ARROW
+
SHIFT LEFT ARROW
while in PIPs mode to freeze the background. Press
FREEZE
+ while in PIPs mode to freeze the foreground tile. Press
SHIFT FREEZE
1 2
6 7
... N ...
OTES
Change mask position.
Change mask border color.
Change mask border style.
Change mask size.
Increase vertical size of mask.
Decrease vertical size of mask.
Increase horizontal size of mask.
Decrease horizontal size of mask.
3 4
8 9
again to release
FREEZE
SHIFT
C 8
HAPTER
+
FREEZE