TP-Link Archer C50(EU)3.0 User Manual page 19

Chapter 4
• IP Address - Enter the IP address in dotted-decimal notation provided by your ISP.
• Subnet Mask - Enter the subnet mask in dotted-decimal notation provided by your
ISP. Normally 255.255.255.0 is used as the subnet mask.
• Gateway - Enter the gateway IP address in dotted-decimal notation provided by your
ISP.
• Primary/Secondary DNS Server
dotted-decimal notation provided by your ISP.
• MTU (Bytes) - The normal MTU (Maximum Transmission Unit) value for most Ethernet
networks is 1500 Bytes. It is not recommended that you change the default MTU size
unless required by your ISP.
• Enable IGMP Proxy
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration
for client devices, such as the modem router. The default value is enabled, and if you
are not sure, please contact your ISP or just leave it.
PPPoE
If your ISP provides PPPoE connection, select PPPoE.
• User Name/Password
These fields are case-sensitive.
• Confirm Password
password you entered is correct.
• Secondary Connection
an extra connection type, select
connection.
• Connection Mode
• Always On - In this mode, the Internet connection will be active all the time.
• Connect on Demand
automatically after a specified inactivity period (Max Idle Time) and be re-
established when you attempt to access the Internet again. If you want to keep
- (Optional) Enter one or two DNS addresses in
- IGMP (Internet Group Management Protocol) is used to manage
- Enter the user name and password provided by your ISP.
- Enter the Password provided by your ISP again to ensure the
- It's available only for PPPoE connection. If your ISP provides
Dynamic IP
- In this mode, the Internet connection can be terminated
or Static IP to activate the secondary
16