Heatilator CRAVE4836-C Installation Manual page 61

3. Unplug the 6V transformer from the junction box.
This will turn the power off to the appliance.
4. Turn the gas shutoff handle to the "OFF" position to
shut off the gas supply.
If additional access is needed, proceed as follows:
5. Remove glass assembly from appliance by unlatch-
ing the top spring latches from the glass frame and
lifting glass frame assembly out of the bottom brack-
et.
6. Remove interior media and refractory from the appli-
ance if already installed.
7. Remove the media tray. It is attached to the interior
firebox bottom with ten screws. See Figure 9.3.
8. Remove the two screws that attach the pilot to the
burner.
9. Remove the four screws securing the burner to the
firebox sides and disengage burner from orifice. Re-
move burner. See Figure 9.3.
10. Remove the eight screws that secure the glass window.
Remove the glass window. Handle with care. See
Figure 9.4.
11. Remove light tray from appliance by lifting up and out
through the bottom glass opening.
PILOT SHIELD
MEDIA TRAY
BURNER 36
BURNER 48
BURNER 60
BURNER 72
Figure 9.3 Media Tray with Burner and Pilot Shield
Heatilator • CRAVE4836-C/ST-C, CRAVE6048-C/ST-C, CRAVE7260-C/ST-C, CRAVE8472-C/ST-C Installation Manual • 2601-980 Rev. N • 11/21
Figure 9.4 Gas and Electrical Access - Remove Glass Window
GAS VALVE
GAS ACCESS
Figure 9.5 Gas Fitting Access with Bottom Glass Shield Removed
61