Teltonika RUT240 User Manual page 50

7.2.2.2.3 PPPoE
Field name
1. Disable NAT
2 Use default gateway
3. Use gateway metric
4. Use DNS servers
advertised by peer
5. LCP echo failure
threshold
6. LCP echo interval
7. Inactivity timeout
Sample value Explanation
Enable/Disable If checked, the router will not perform NAT (masquerade) on this
interface
Enable/Disable If unchecked, no default route is configured
0 The WAN configuration by default generates a routing table
entry. With this field you can alter the metric of that entry
Enable/Disable If unchecked, the advertised DNS server addresses are ignored
0 Presume peer to be dead after given amount of LCP echo failures,
use 0 to ignore failures
5 Send LCP echo requests at the given interval in seconds, only
effective in conjunction with failure threshold
0 Close inactive connection after the given amount of seconds, use
0 to persist connection
50