Bluetooth - JVC KD-R985BTS Instruction Manual

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
MIC (microphone input terminal)*
Rear panel
Adjust the microphone
angle
Secure using cord clamps
(not supplied) if necessary.
* KD-RD88BT/KD-R780BT: Connect to the microphone input
jack. ( 36)
14
ENGLISH
JS_JVC_KD_R985BTS_K_EN_5.indd 14
Pair and connect a Bluetooth device for the first time
1
Press
2 Search and select "KD-R9
"KD-RD8 BT" on the Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number
(PIN) code immediately after searching.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) "[Device Name]"
(B) "[Device Name]"
Microphone (supplied)
"PAIRING COMPLETED" appears when pairing is completed and " " will light up when the
Bluetooth connection is established.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if
you reset the unit. To delete the paired device,
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at
any time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio devices and
switch between these five devices. ( 19)
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
to turn on the unit.
BTS"/"KD-R8
"XXXXXX"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the volume knob to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
"VOL – YES"
Press the volume knob to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. ( 18)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
BTS"/"KD-R7 BT"/"KD-RD9 BTS"/
"VOL – YES" "BACK – NO"
"BACK – NO"
18, [DEVICE DELETE].
8/8/2016 9:31:38 PM