Setting The Signal; Cleaning And Maintenance; Machine Housing/Control Panel - Bosch WAT Series Instruction Manual And Installation Instructions

M

Setting the signal

You can change the following settings:
S e t t i n g t h e s i g n a l
The volume of the buttons and
■
information signals (e.g. at the end
of the program) and/or
The volume of the button signals.
■
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
Select the Cottons program to
1.
position 1. The washing machine is
switched on.
Press the A button and, at the
2.
same time, turn the program selector
clockwise to position 2. Release the
button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel
(e.g. at the end of the program).
Changing the volume
Use the Finished in-time + or - button
to change the following settings at the
corresponding program selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Exiting setting mode
You can now end the process and set
the program selector to the Off position.
The settings are saved.
Setting the signal
2
Cleaning and
maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Danger of death!
There is a risk of electric shock if you
touch live components.
Switch off the appliance and pull out the
mains plug.
:
Warning
Risk of poisoning!
Toxic vapours can be produced by
cleaning agents that contain solvents,
e.g. cleaning solvent.
Do not use cleaning agents that contain
solvents.
Caution!
Damage to the appliance
Cleaning agents that contain solvents,
e.g. cleaning solvent, can damage
surfaces and components in the
machine.
Do not use cleaning agents that contain
solvents.
Prevent detergent residue from
building up and odours from forming
by following these instructions:
Notes
Ensure the room in which the
■
washing machine is set up is well
ventilated.
Leave the door and detergent
■
dispenser tray open slightly when the
washing machine is not in use.
Occasionally run a wash using the
■
Cottons 60 °C programme and
powder detergent.
Machine housing/control
panel
Wipe the housing and the control
■
panel with a soft, damp cloth.
Remove the detergent residue
■
immediately.
Do not clean with a water jet.
■
en
21