Start The Programme; Childlock - Bosch WAT Series Instruction Manual And Installation Instructions

Operating the appliance
en
Pour the detergent and care products
into the appropriate compartments:
Measuring aid for liquid detergent
A
Dispenser II Detergent for the main wash,
water softener, bleach, stain
remover
Dispenser i Softener, starch,
do not exceed max.
Dispenser I Detergent for prewash
Pull out the detergent drawer as far
1.
as possible.
Add detergent and/or care products.
2.
Close the detergent drawer.
3.
Measuring aid* for liquid detergent
Position the measuring aid for dosing
the correct amount of liquid detergent:
Pull out the detergent drawer.Press
1.
down the insert and fully remove the
drawer.
Slide the measuring aid forwards,
2.
fold it down and click it into place.
Reinsert the drawer.
3.
Do not use the measuring aid for
Note:
gel detergents and washing powder, or
for programs with prewash or when the
"Ready in" time is selected.
18

Start the programme

Press the A button. The indicator lamp
lights up and the program starts.
The display panel shows the Ready in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Display panel ~ Page 10
Note: Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Childlock

(E 3 sec., E 3 δευτ.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To activate/deactivate, press and hold
the Spin speed and Finished in-time
buttons at the same time for approx.
three seconds.The E symbol appears in
the display panel.
E lights up: The childproof lock is
■
active.
E flashes: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.