Faults And What To Do About Them; Emergency Release; Information On The Display Panel - Bosch WAT Series Instruction Manual And Installation Instructions

Faults and what to do about them.

en
3
Faults and what to do
about them.

Emergency release

F a u l t s a n d w h a t t o d o a b o u t t h e m .
e.g. in the event of a power cut
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.

Information on the display panel

Display
è lights up
è flashes
r lights up
24
Cause/Remedy
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the A button to continue the program.
Laundry may be caught. Open and close the door again and press the A
■
button.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the program and make
■
your individual settings; start the program.
Turn on the cold water tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 23
■
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Switch off the appliance. Disconnect
1.
the mains plug.
Drain the detergent solution
2.
Pull the emergency release
3.
downwards with a tool and release.
The washing machine door can then
be opened.
.