Electrical Connection; Before Washing For The First Time - Bosch WAT Series Instruction Manual And Installation Instructions

Positioning and connecting
en

Electrical connection

:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Never unplug the mains plug during
■
operation.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The washing machine is only
■
connected to an alternating current
supply via a properly installed
earthed socket.
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from customer
services.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays the
z symbol is used.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not kinked,
■
squashed, altered or cut through.
The mains cable does not come into
■
contact with heat sources.
34
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 28).
Never use a damaged machine.
■
Inform customer services.
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Close the door (do not load any
5.
laundry).
Depending on the model, run the
6.
Drum Clean 90 °C or Cottons 90 °C
program.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Pour standard detergent into
9.
compartment II.
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for wool or delicates.
Close the detergent drawer.
10.
Press the A button.
11.
When the program ends, switch off
12.
the appliance.
Your washing machine is now ready to
use.