Table of Contents
Advertisement
Setting the signal
en
M
Setting the signal
Y ou can change the following settings:
S e t t i n g t h e s i g n a l
The volume for the information
■
signals (e.g. at the end of the
program) and/or
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
1/2/3/...
positions on the program
selector
Activate setting mode:
Set the program selector to
1.
position 1. The washing machine is
switched on.
Press the A Start/Reload button
2.
and, at the same time, turn the
program selector clockwise to
position 2.Release the button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel
(e.g. at the end of the program).
32
Changing the volume
Use the ñ Finished in button to
change the following settings at the
corresponding program selector
positions:
2: The volume of the information
■
signals and/or
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Exiting setting mode
You can now end the process and set
the program selector to the Off position.
The settings are saved.
H
Sensors
U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.
Advertisement
Table of Contents
