The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAT Series Instruction Manual And Installation Instructions

Place the service flap back on, lock
6.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Empty programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Cleaning and maintenance
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any program
2.
(except Rinse//Spin/Empty).
Press the A button.Allow the
3.
program to run for approximately
40 seconds.
Turn the program selector to Off.
4.
Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
7.
leaks.
en
23