Pitch Curve (Standard Gui); Gyro Sensitivity (Standard Gui); Switch Assignment (Standard Gui); Throttle Hold (Standard Gui) - Deviation Devo7e User Manual

Pitch Curve (Standard GUI)

The pitch curve allows defining a piece-wise
linear curve for the collective/pitch channel.
Different curves can be selected for each flight-
mode as well as for throttle-hold. Each point
value can be enabled to be interpolated from the
points surrounding it.

Gyro Sensitivity (Standard GUI)

The gyro-sensitivity page enables configuring up-
to 3 sensitivity values for the gyro as well as
which channel to use for sending the gyro value.

Switch Assignment (Standard GUI)

The switch assignment page enables configuring
which switches to use for each capability in the
standard-GUI. The same switch may be assigned
to multiple capabilities.

Throttle Hold (Standard GUI)

The throttle-hold page is used to enable/disable
the throttle-hold capability. Specifying 'Hold
position' defines the throttle value when the
Throttle-hold switch is set.

Fail-Safe Configuration (Standard GUI)

The fail-safe page is used to configure the fail-
safe value for each channel (if the protocol
supports this feature)
Page | 31