Servo Travel Adjust (Standard Gui); Swash Configuration (Standard Gui); Dual-Rate/Expo Setting (Standard Gui); Throttle Curve (Standard Gui) - Deviation Devo7e User Manual

Servo Travel Adjust (Standard GUI)

The servo-travel adjust page configures the
maximum positive/negative travel of each servo.
This is equivalent to the 'Scale+' and 'Scale-'
settings on the Channel Configuration sub-page
of the Mixer menu when using the Advanced
Mixer (see page 20)

Swash Configuration (Standard GUI)

The Swash configuration page configures the
swash type. These settings are equivalent to the
settings on the 'Helicopter' configuration sub-
page of the Model page (see page 21).
The available values are:
1Servo: Used For FBL. All mixing occurs in Rx
•
3Servo 120: 120-degree swash
•
3Servo 120x: 120 degrees swash (alternate config)
•
3Servo 140: 140 degree swash
•
3Servo 90: 90 degrees swash
•

Dual-Rate/Expo setting (Standard GUI)

The dual-rate and expo page allows configuration
of curves for the Aileron, Rudder, and Elevator
channels. Up-to 3 rates can be configured for
each channel, and either a scaled-linear or
exponential curve can be selected for each. The
number of settings depends on the switch
assigned to the dual-rates function on the Switch
Assignment page (see page 31)

Throttle Curve (Standard GUI)

The throttle curve page allows defining a piece-
wise linear curve for the throttle channel.
Different curves can be selected for each flight-
mode. Each point value can be enabled to be
interpolated from the points surrounding it.
Page | 30