Standard Gui; Servo Reverse (Standard Gui); Sub-Trim Adjustment (Standard Gui) - Deviation Devo7e User Manual

Standard GUI

The Standard GUI is an alternative interface
from the Advanced GUI'. Which interface is
used is chosen by the 'Mixer GUI' on the Model
Page. The Standard GUI is only available for
Helicopter-type models at this time. The pages
of the Standard GUI are as follows:
1. Model setup: Model configuration page (See page 21)
2. Reverse: Servo reverse (See page 29)
3. D/R & Exp: Dual-rates setup (See page 30)
4. Subtrim: Servo sub-trim (See page 29)
5. Travel adjust: Servo travel-adjust (See page 30)
6. Throttle curves: Throttle curve setup (See page 30)
7. Pitch curves: Pitch curve setup (See page 31)
8. Throttle hold: Throttle-hold configuration (See page 31)
9. Gyro sense: Gyro-sense configuration (See page 31)
10. Swash: Swash Setup (See page 30)
11. Fail safe: Fail-Safe configuration (See page 31)
12. Switch assignment: Assign switch controls (See page 31)
13. Timers: Timer configuration (See page 27)
14. Telemetry config: Configure telemetry alarms (See page 28)
15. Main page config: Configure main page display (See page 12)

Servo Reverse (Standard GUI)

The servo reverse page allows quickly setting
each channel to work in either normal or reversed
mode. These settings are equivalent to the
'Reverse' setting on the Channel Configuration
sub-page of the Mixer menu when using the
Advanced Mixer (see page 20)

Sub-trim Adjustment (Standard GUI)

The sub-trim adjust page allows setting the zero-
point of the servos for each channel. This is
equivalent to the 'Subtrim' setting on the
Channel Configuration sub-page of the Mixer
menu when using the Advanced Mixer (see page
20)
Page | 29