ETC Eos Remote Processor Unit 3 Setup Manual

ETC Setup Guide
®
Eos Remote Processor Unit 3 (RPU 3)
This guide outlines the setup and configuration of your Eos Remote Processor Unit 3 (RPU 3). For
information on using the Eos software installed on your RPU, please refer to the Eos Ti, Eos, and
Gio Operations Manual that shipped with your console or you may download it from our website
at www.etcconnect.com.
The Eos RPU 3 can be used as a primary, backup, or client processor with any Eos Family desk,
other than Element. It can also be used for independent playback applications. Eos RPU 3 ships
with the following:
• Remote Processor Unit
• USB Keyboard
• USB Mouse
• Rack Mount Hardware Kit
• IEC Power cord
• Three Active Display Port to DVI-D Adapters
• Label Set
• Setup Guide and Current Release Note Documentation

Hardware Setup

Rear Panel

Hard Power Switch
IEC Power
Connector
Step 1:
Corporate Headquarters
London, UK Tel +44 (0)20 8896 1000

Rome, IT Tel +39 (06) 32 111 683

Holzkirchen, DE
Hong Kong Tel +852 2799 1220

Web: www.etcconnect.com
4350M2200 Rev B

RPU 3
USB 2.0 ports
Display Ports
Attach the IEC power cord to the power connector.
Middleton, WI, USA Tel +608 831 4116
 
Service: (UK)

Service: (UK) service@etceurope.com

Tel +49 (80 24) 47 00-0 Service: (DE)
 
Service: (Asia) service@etcasia.com

© 2015 ETC. All Rights Reserved.

Released 2015-02 ETC intends this document to be provided in its entirety.
 
Ethernet
Ports 1 & 2
Audio Ports
(Not Currently
Enabled)
Service: (Americas)

service@etceurope.com
techserv-hoki@etcconnect.com
Product information and specifications subject to change.

Page 1 of 3
Phone
Remote
DMX x2
Remote
Midi In
Trigger
& Out
service@etcconnect.com
Electronic Theatre Controls, Inc.