Replacing The Optical Drive - Lenovo s200 Hardware Maintenance Manual

8. Install the new card reader into the bracket.
Figure 26. Installing the card reader
9. Install the two screws to secure the card reader to the bracket.
10. Install the card reader bracket into the chassis and align the screw hole in the bracket with the
corresponding hole in the chassis.
Figure 27. Installing the card reader bracket
11. Install the screw to secure the card reader bracket to the chassis.
12. Reconnect the card reader cable to the card reader connector on the system board. See "Parts on the
system board" on page 34.
13. Install the front bezel. See "Replacing the front bezel" on page 83.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 109.

Replacing the optical drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the optical drive, do the following:
.
Chapter 9 Installing or replacing hardware
93