Lenovo s200 Hardware Maintenance Manual page 100

1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Remove the front bezel. See "Replacing the front bezel" on page 83.
4. Locate the optical drive. See "Computer components" on page 31.
5. Disconnect the signal cable and the power cable from the rear of the optical drive.
6. Remove the four screws that secure the optical drive, and then slide it out of the front of the computer.
Figure 28. Removing the optical drive
7. Slide the new optical drive into the optical drive bay from the front of the computer until the four screw
holes in the optical drive align with the corresponding screw holes in the chassis.
Figure 29. Installing the optical drive
8. Install the four screws to secure the optical drive to the chassis.
9. Connect the signal cable and the power cable to the rear of the optical drive.
10. Reinstall the front bezel. See "Replacing the front bezel" on page 83.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 109.
94
Lenovo S200 Hardware Maintenance Manual