Replacing The Front Audio And Usb Assembly - Lenovo s200 Hardware Maintenance Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 109.

Replacing the front audio and USB assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the computer handle, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Remove the front bezel. See "Replacing the front bezel" on page 83.
4. Locate the front audio and USB assembly. See "Computer components" on page 31.
5. Disconnect the front audio and USB assembly cables from the system board.
Note: Ensure that you note the locations of the cables when you disconnect the cables from the
system board.
6. Remove the screw that secures the front audio and USB assembly bracket. Then, pivot the front audio
and USB assembly bracket as shown to remove it from the chassis.
Figure 20. Removing the front audio and USB assembly bracket
.
Chapter 9 Installing or replacing hardware
89