Mounting; Orientation; Rigging; Procedure - Chauvet WELL Fit User Manual

Setup

Mounting

Orientation

Rigging

Procedure

Mounting Diagram
-10-
Before mounting this product, read and follow the
Professional line of mounting clamps, go to http://trusst.com/products/.
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
Chauvet recommends using the following general guidelines when mounting this product.
·
When selecting an installation location, consider easy access to this product for operation,
programming adjustments, and routine maintenance.
·
The product is not intended for permanent installation.
·
Make sure to mount this product away from any flammable material as indicated in the
Safety Notes.
·
If hanging this product, make sure that the mounting location can support the product's
weight. See the Technical Specifications
product.
·
When hanging this product, always secure to a fastening device using a safety cable. For
our CHAUVET Professional line of safety cables, go to http://trusst.com/products/.
The WELL Fit comes with an M12 threaded mounting hole to which you can attach mounting
clamps for hanging. When mounting the product overhead, always use a mounting clamp and
safety cable. Mount the product securely to a rigging point, such as a pipe or truss. When
rigging the product, you should use a mounting clamp of appropriate weight capacity. You must
supply your own mounting clamps. Use at least one mounting point per product. For our
CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
When mounting the product on the floor, make sure that the product and any cables are away
from people and vehicles.
Handle
Floor Mounting
Safety Notes. For our CHAUVET
for the weight-bearing requirements of this
M12 Threaded
Mounting Hole
Overhead Mounting
WELL Fit User Manual Rev. 5