Fisher & Paykel SmartLoad DE62T27GW1 Installation Instructions And User Manual page 26

3-Wire Connections
For use where local codes permit grounding through the Neutral wire.
Use approved 3-wire Power Supply Cord or a 3-wire Cable for Direct Wiring as described on page 24.
Remove the terminal block cover plate.
1
Insert the power cord with a UL listed strain relief through the hole provided in the cabinet near
2
the terminal block. Do not tighten strain relief screw until wiring connections are complete.
Note:
a strain relief must be used.
Loosen or remove the center terminal block screw. Connect the neutral wire (center) of the power
3
supply cord to the center terminal screw of the terminal block. Tighten screw.
Connect the other wires to the upper and lower terminal block screws marked with the
4
letter L. Tighten screws.
Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer. Secure
5
cover with securing screw.
Tighten strain relief screws.
6
26
2
5
strain relief
clamp sections
strain relief
screws
4
3
4
6