Winding The Bobbin - JUKI HZL-60 series Instruction Manual

Winding the bobbin

1. Place the thread and spool
2. Snap the thread into the
3. Wind the thread clockwise
4. Place the thread end through
5. Push the bobbin to right.
6. Hold the thread tail securely
7. Press on the foot control or
8. After the bobbin has wound a
9. Cut the thread and then
- When the bobbin winder
- If you find the bobbin winding
14
cap onto the spool pin.
For smaller spools of thread,
place spool cap with the
small side next to the spool
or use the small spool cap.
thread guide.
around the bobbin winder
tension discs.
one of the inner holes in the
bobbin as illustrated and
place empty bobbin on the
spindle.
in one hand.
the Start/stop button to start
winding the bobbin.
few turns stop the machine
and cut the thread near the
hole of the bobbin. Continue
filling the bobbin until it is full.
Once the spool is full, it
rotates slowly. Release the
pedal or stop the machine.
Push the bobbin winder
spindle to left.
remove the bobbin.
Note:
switch is placed on the right
"bobbin winding position", the
buttons will not work. To start
sewing, push the bobbin
winder switch to the left
"sewing position".
the thread unevenly, you can
adjust the height of the winder
tension disc (3) to improve it.