Sony SRS-X99 Help Manual page 228

Help Guide
How to Use
Personal Audio System
SRS-X99
Connection method 1: Connecting to a Wi-Fi network using the WPS button of a wireless router
If your wireless router has a WPS button, you can connect to the Wi-Fi network by the following method.
To check if your wireless router is compatible with WPS (Wi-Fi Protected Setup), refer to the operating instructions of
your router.
Do the following before starting.
Disconnect the LAN cable (not supplied) from the speaker.
Place the speaker near the wireless router.
Set the Wi-Fi antenna on the rear to the upright position.
1. Turn on the speaker.
The (on/standby) indicator lights up in green, then the LINK indicator begins to flash.
When you configure the settings of the speaker for the first time after purchase, or after initializing the speaker, wait
about two minutes until the LINK indicator flashes slowly (blinks once in three seconds).
2. Press and hold the WPS button on the rear of the speaker until a beep sound is heard (for about 2 seconds).
The LINK indicator flashes in orange.
3. Press the WPS button
Operate within 90 seconds after pressing the WPS button of the speaker. Depending on the wireless router, you
may need to press and hold the WPS button for a few seconds. For details, refer to the operating instructions
supplied with the router.
*
of the wireless router.
219