Introduction - Chint Power CPS SCE4 Installation And Operation Manual

1. Introduction

This manual describes all the information needed to install and operate the
following PV Inverter Models:
CPS SCE4KTL-O/US, CPS SCE5KTL-O/US, CPS SCE6KTL-O/US, and
CPS SCE7KTL-O/US
IMPORTANT
In order to avoid problems during the installation, it is
recommended to read the entire user manual before any
installation procedures.
Any improper usage may result in damage to the unit. Therefore, it is
important that all installation procedures shall be completed by qualified
personnel that have been trained to install and operate PV Inverters.
Moreover, this user manual only describes the information that is needed for
the CPS grid-tied PV Inverter and does not cover any installation information
relating to other equipment installed in the PV system. The following safety
instruction should be followed:
WARNING
It is necessary that only qualified personnel conduct the
installation and operation of the PV Inverter. Otherwise, risk of
damage to or destruction of part or all of the Inverter and/or other
equipment connected to the Inverter or personal injury due to
improper installation procedures or practices.
ELECTRIC SHOCK
Alternating Current (AC) and Direct Current (DC) sources are
directly connected to the terminals in the PV Inverter. In order to
prevent risk of electric shock before maintenance or installation, it
is necessary to ensure that all AC and DC terminals are
disconnected.
HOT SURFACE
Although the inverter is designed to meet international safety
standards, the surface of the inverter can become hot during
operation. Therefore, do not touch the heat sink or peripheral
surfaces during or shortly after operation.
Page 4 Copyright CPS America Co., Ltd.