Micro-Sd Card - Foscam R2 User Manual

Front panel:
LENS: Fixed focus lens.

Infrared LED: Infrared LEDs for night vision.

Microphone: Built-in microphone.

Micro SD Card slot: Supports up to 64GB SD card for storing the video.

WPS/Reset

WPS: Push both WPS/Reset button on the camera and wireless router within 1 minute, the

camera will connect to the wireless router automatically, in WPS process, the Network light will
blink every 0.4 seconds;
Reset: Push and hold the WPS/Reset button for more than 10 seconds to set the camera to

factory default, the Power light will blink every 0.4 seconds;
Rear panel:
LAN: 10/100 Mbps RJ-45 port for wired connection

Power: DC 5V/2A Power supply.

Speaker: Built-in speaker

Antenna: Used to connect external wireless antenna

The flashing status of the Power light and Network light are shown in the following table.
Light Flashing Status
Power light off
on
Flashing every 0.4 seconds
Network light off
Constant Flash
Slow Flash every 1.0 second
Flashing every 0.4 seconds
Flashing every 0.2 seconds

1.5 Micro-SD Card

This camera supports SD Card.
When you plug in the SD card during the camera work process, please reboot the camera again, or else
the SD Card may be cannot work well.
SettingsDevice StatusDevice Status
Go to the
Description
The power don't work properly.
The power supply works fine.
Reset to take effect
No Wireless connection
Wired connection
Wi-Fi connected
WPS is connecting
EZLink takes effect
page, you can see the SD card status.
3