Product Specifi Cations; Fireplace Controls; Gas Specifi Cations & Orifi Ce Sizes; Cold Climate Insulation - Vermont Castings 33CFDV(N/P)(V/I)SB Installation And Operating Instructions Manual

CFDV Series Gas Fireplace
faster and more effi cient. Operating your appliance in cold
climate (aka standing) pilot mode will prohibit the need for
multiple ignition attempts and will prevent the system from
delaying start up or locking out.
Figure 2 –
CFDV Fireplace Controls–IPI (featuring Cold Climate option)

BEFORE YOU START

Read this homeowner manual thoroughly and follow all
instructions carefully. Inspect all contents for shipping
damage and immediately inform your dealer if any damage
is found. Do not install any unit with damaged, incomplete,
or substitute parts. Check your packing list to verify that
all listed parts have been received. You should have the
following:
• Fireplace (Firebox and Burner System)
• Log Set
• Rock Wool
• Volcanic Rock

ITEMS REQUIRED FOR INSTALLATION

Tools and Building Supplies:
• Phillips Screwdriver
• Hammer
• Pliers
• Square
• Level
• Tee Joint
• Pipe Wrench
• Saw and/or saber saw
• Measuring Tape
• Electric Drill and Bits
• Framing Materials
6
To activate the cold climate option, simply move the cold
climate toggle switch located on the right side of the black
control center to the "On" (left) position. (Figure 2) You can
operate your appliance in this mode regardless of whether
you are using a remote control, wall switch or thermostat.
Control Board
•
•
•
•
•

FIREPLACE FRAMING

Firebox framing can be built before or after the appliance
is set in place. Construct fi rebox framing following Figure
3 (page 6) for specifi c installation requirements and for
fi rebox dimensions. The framing headers may rest on the
top of the fi rebox standoffs. Do not bring headers below
top of standoffs.
The fi rebox may be installed directly on a combustible fl oor
or raised on a platform of an appropriate height. When
the fi rebox is installed directly on carpeting, tile, or other
combustible material, other than wood fl ooring, the fi rebox
shall be installed on a metal or wood panel extending the
full width and depth of the enclosure.

PRE-INSTALLATION INFORMATION

Wall Finishing Materials
Caulking Material (Noncombustible)
Fireplace Surround Material (Noncombustible)
Piping Complying with Local Codes
Pipe Sealant Approved for use with Propane/LPG
(Resistant to Sulfur Compounds)
Do not fill spaces around firebox with
insulation or other materials. This could
cause a fi re.
Master Switch
Cold Climate Switch
LED indicator
20306739