Ipi System - Vermont Castings 33CFDV(N/P)(V/I)SB Installation And Operating Instructions Manual

CFDV Series Gas Fireplace

IPI SYSTEM

OPERATION
Install batteries and/or
plug in the AC adapter
Flip the master switch
to the ON position
Press the wall switch
to ON position
Cold climate switch
50
FAULT
A
No beep in about
5 seconds
Check NG/LP
No beep
conversion cap
or B
and control
no sound from the
board
valve indicating pilot
connections
solenoid open
C
No sparking on
the pilot
D
The Control Board is having interference from the
Sparking doesn't
continue surrounding metal (Ground)
E
Check gas supply
Pilot doesn't light
F
Main burner doesn't Go through
light
Check the cold climate switch and control board
No function
connector
DIAGNOSIS
Using Battery polarity wrong?
battery?
Make sure
control board Battery voltage low?
is connected
to wire
harness to
battery pack
AC plug is plugged to
AC mains?
The 5-pin connector on
Using
the AC board broken or
AC power?
bent?
LED on the wire
harness does not show
solid green?
Check valve
connections
Check pilot Check
grounding
connections
Go through C
The sensor on the pilot
E
is not in the flame
(pilot flame too small)?
TROUBLESHOOTING
ACTION
Re-install batteries
Change batteries
Plug the AC plug to
AC mains
Repair or replace the
AC adapter
Replace the AC adapter
Check power
Replace the Control
supply (go
Board
through )
A
Sparking is happening
Go through
elsewhere (under the
B
pilot), re-install/replace
the pilot
Re-install the Control
Board, move it around
or change the
Control Board
Sparking is not in the
path of gas flow, adjust
sparker position or
replace the pilot
Adjust sensor position
or replace the pilot
Replace cold climate
switch
20306739