Venting Installation Information; Optional Top Vent Application - Vermont Castings 33CFDV(N/P)(V/I)SB Installation And Operating Instructions Manual

CFDV Series Gas Fireplace

OPTIONAL TOP VENT APPLICATION

The appliance is shipped as a rear vent unit. If the installa-
tion layout requires the unit to be a top vent confi guration
the appliance can be converted by following the steps
below.
When removing and refi tting the plates be sure the associ-
ated gaskets are undamaged and refi tted as required.
1. Remove the rear plate by removing one (1) screw. Set
aside. Figure 8
Figure 8 –
Remove Rear Plate
2. Remove the plate with the 7" collar and gasket by re-
moving eight (8) screws. Set aside. Figure 9
Remove
Screws
7" Collar
Remove
Screws
Figure 9 –
Remove 7" Collar and Gasket
10
Screw
Rear Plate
FP3021
FP3022
3. Remove the plate with the 4" collar and gasket by re-
moving four (4) screws. Set aside. Figure 10
4. Remove the top plate located on top of the unit by re-
moving one (1) screw. Set aside. Figure 10
Top Plate
Remove
Screws
4" Collar
Figure 10 –
Remove 4" Collar and Gasket and Top Plate
5. Remove one (1) screw to remove the inner top plate
located on top directly beneath the plate just removed.
Break away the 7" circle using a screwdriver and rein-
stall. Figure 11
Remove Circle
Figure 11 –
Remove Circle Section from Inner Top Plate
VENTING INSTALLATION
Remove
Screw
Remove
Screws
FP3023
Inner Top Plate
FP3025
20306739
FP3024