Remote Wall Mounted Switch; Remote Wall Switch; Optional Dc Remote Systems - Vermont Castings 33CFDV(N/P)(V/I)SB Installation And Operating Instructions Manual

CFDV Series Gas Fireplace

REMOTE WALL MOUNTED SWITCH

A remote wall switch and up to fi fteen (15) feet of 18 Ga.
wire may be used with this appliance. Attach the wall
switch in a junction box at the desired location on the
wall. Figure 54. Do not extend beyond the wall switch wire
length provided.
NOTE: Extended lengths of wire may cause the fi replace
not to function properly. Longer length of wire is permitted
if the wire is made out of larger gauge (diameter) wire.
Always check with local code.
PILOT HI
TH
TP
TH/TP
Figure 54 –
Wiring Diagram for Wall Switch

REMOTE WALL SWITCH

Position the wall switch. Do not extend beyond the 15 feet
of wire.

OPTIONAL DC REMOTE SYSTEMS

See section entitled Hearth Mount in the Millivolt hand held
remote instructions supplied with the remote.
1. Using a fl at head screw driver, bend the "remote" tabs
up from the bottom of the fi replace. Figure 55
2. Follow the instructions on remote control to snap the
remote cover plate to the remote receiver
3. Connect the wire terminal from the remote receiver.
Figure 54
4. Use the screws that came with the remote control to
mount the remote receiver cover to the bent up "remote"
tabs. Figure 55
30
ELECTRICAL INSTALLATION – MILLIVOLT
Do not connect wall switch to (110 V)
circuit.
REMOTE
WALL SWITCH
OPTIONAL REMOTE
CONTROL RECEIVER
Remote
Tab
Remote Control
Receiver
Figure 55 –
Optional Control Location
ON
OFF
ON
OFF
Optional Blower
Speed Control
20306739
FP3032
FP3019