Ecologic Control System Operation And Indications - Vermont Castings 33CFDV(N/P)(V/I)SB Installation And Operating Instructions Manual

CFDV Series Gas Fireplace
40
OPERATIONS AND INDICATIONS
RF Learn
Button
System Set Up Chart
NOTE: When using ON/OFF wall switch, the master switch, located in bottom of fireplace must be in
the ON position to perform all configuration setup operations.
FUNCTION OPERATION
Cold Climate Pilot On/Off Flip the toggle switch to ON.
Push the RF Learn Button on Control Board (use a paper clip)
RF Receiver Learn Button until you hear a beep. Then press any button on a handheld
remote approved for the fireplace.
Operations
FUNCTION OPERATION
Power Up Flip the Master Switch to ON position to power up the system.
Turn on wall switch to turn the fireplace on. NOTE: If master switch was
Fireplace On just switched to ON, then at first use of wall switch, it may need to be
turned ON - OFF - ON to synchronize the two switch settings.
Turn the wall switch to the OFF position, or turn the ON/OFF master
Fireplace Off
switch to the OFF position
Self Diagnostics Chart
The fireplace has a self diagnostic LED display next to the Master Switch enabling you to troubleshoot
problems and potentially avoid a service call. Please refer to the chart below for indicator reference.
FUNCTION OPERATION
Control Board Chip Cover
One RED (1 time)
Missing
Spark Fail Two RED (1 time)
No Sensor Signal Three RED (1 time)
Trial Lockout One GREEN, every 2 seconds (until manual reset)
Flames Loss Lockout One RED-GREEN, every 2 seconds (until manual reset)
AC Power On GREEN Solid
Remote Operations
The following functions are available on the RMSC handheld remote.
NOTE: Flame height control is only available with purchase and installation of a stepper motor kit.
REMOTE FUNCTION OPERATION
Fireplace On Press the ON button on the transmitter.
Press the OFF button 3 times or hold the OFF button 3
Fireplace Off
seconds for memory off.
Press the ON button once to turn on the fireplace with
Flame Height Up
maximum flame setting.
Press the OFF button to lower the flame height to
Flame Height Down
medium and low.
Press TIMER button to enter the timer mode. Keep
Count Down Timer Mode pressing the TIMER button to set the desired time or
press TIMER button to "0" to exit timer mode.
OPERATING INSTRUCTIONS – IPI
Cold
Climate
Switch LED
Master
Switch
ICON
DEFAULT
SETTING
OFF
20306739