Related Manuals for quiko Moovy QK-M300B
Summary of Contents for quiko Moovy QK-M300B
- Page 1 MOOVY AUTOMATIONS FOR SLIDING GATES (230/110/24V) V07/2017...
- Page 2 “ Machinery Directive”. It is on the installer to verify its security. WARNING: Quiko Italy Sas is not liable for any damages to people, animals or things due to...
-
Page 3: Materials For Installation
2- MATERIALS FOR INSTALLATION FIG. 1 1. Gearmotor 2. Counterplate 3. Limit switches brackets (cammes) 4. M4 rack (NOT INCLUDED) 5. M10 Anchor bolts (NOT INCLUDED) 3- POSITIONING THE COUNTERPLATE Dig a concrete foundation base following measurements shown on fig. 2, 3. Position the counterplate making sure it is perfectly levelled and smooth and complying with the measurements shown on fig. - Page 4 FIG. 3...
- Page 5 FIG. 4 6- POSITIONING THE LIMIT SWITCHES BRACKETS (CAMMES) FIG. 5 Manually position the gate completely open and fasten the limit switch brackets (1) (2) onto the rack so that the limit switch lever exceeds the length of the brackets by approximately two/thirds. Repeat the operation with gate completely closed.
- Page 6 7- UNLOCKING THE MOTOR MANUALLY FIG.6 RELEASE INSTRUCTION In case of fault or power failure, insert the key in the lever lock and turn it of 90°CW. Pull and turn the lever approx. 90°until it stops and the gate move manually. WARNING: perform locking and lock release operations with motor cut off.
-
Page 7: Typical Installation
9- TYPICAL INSTALLATION FIG. 9 CONNECTIONS CABLES Cables section sqmm POWER SUPPLY 3x1,5 TX PHOTOCELL ON POST 2x0,75 RX PHOTOCELL ON POST 4x0,75 TX PHOTOCELLS 2x0,75 RX PHOTOCELLS 4x0,75 KEY SELECTOR FLASHING LAMP AERIAL RG59 FOR THE ELECTRICAL CONNECTIONS REFER TO THE USER MANUAL OF THE CONTROL BOARD... -
Page 8: General Advice
GENERAL ADVICE Install a gate’s safety system that complies with current regulations. Choose short routes for cables and keep power cables separate from control ones. Install the control card in a waterproof box. Please refer to current regulations when setting the gear motor’s maximum torque. We advice you to install an outdoor switch, in compliance with European standards on the issue of safety, to turn the electricity off when servicing the gate. -
Page 9: Declaration Of Conformity
DECLARATION OF CONFORMITY (OF THE MANUFACTURER) Manufacturer: QUIKO ITALY SAS Via Seccalegno, 19 36040 Sossano (VI) Italia hereby declares, under his liability, that the products: QK-M300B, QK-M600, QK-M600B QK-M800, QK-M1200, QK-M1500, QK-M2000 are in compliance with the essential safety requirements of the regulations: Electromagnetic Compatibility Directive ......2004/108/EC... - Page 10 DECLARATION OF CONFORMITY (OF THE INSTALLER) The undersigned: Address: in charge of the set-up, declares that the product: Gate type: Location: are in compliance with the essential safety requirements of the regulations: Electro magnetic Compatibility Directive ......2004/108/EC Low Voltage Directive ............2006/95/EC Machinery Directive ..............2006/42/EC and also declares that the related and/or specific national technical regulations have been followed:...
- Page 12 QUIKO ITALY Via Seccalegno, 19 36040 Sossano (VI) - Italy Tel. +39 0444 785513 Fax +39 0444 782371 info@quiko.biz www.quikoitaly.com...