Canon PIXMA iP4200 Quick Start Manual page 6

(B)
protective cap
Do not touch the electrical
contacts.
ink tank lamp
4
1
Unpack the cyan ink tank.
2
Pull the orange tape (A) completely off
in the direction of the arrow and remove
(A)
the clear film. Then, remove the film (B).
3
Hold the ink tank as shown in the
diagram and remove the orange
protective cap located on the bottom of
the ink tank.
• Do not squeeze the side of
ink tanks as this may cause
the ink to leak out and stain
your clothes and hands.
• Do not touch the open ink
port.
• Do not reattach the
protective cap once you
have removed it.
4
Insert the cyan ink tank into the right-
hand slot. Press the
tank until it clicks into place and then its
red lamp lights.
5
Use the same procedure to install the
other ink tanks into their appropriate
slots.
Check the labels to make sure that each tank is in the
correct position.
Ensure that all the ink tanks are installed in the order
directed by the label. The printer cannot be used
unless all the ink tanks are installed.
6
Put back the Inner Cover and close the
Top Cover.
The ALARM lamp still flashes orange if an ink tank
is not installed properly. Open the Top Cover and
make sure that all the ink tanks are installed in the
correct order directed on the label.
ink port
mark on the ink