Table of Contents
Advertisement
ALA27
PAGER PROGRAMMING SOFTWARE
ALA27 Programming
This value represents the battery voltage level necessary for the battery gauge
to display a full battery. If the battery voltage is higher or equal to this value,
the full battery gauge icon is displayed. Valid selections are: 2.54V, 2.50V,
2.48V, 2.46V, 2.43V, 2.40V, 2.38V, 2.35V, and 2.30V. The High level must be
greater than the Med level, and the Med level Must be greater than the Low
level. None of the levels can be equal to each other.
This value represents the battery voltage level necessary for the battery gauge
to display a full battery. If the battery voltage is higher or equal to this value,
the full battery gauge icon is displayed. Valid selections are: 2.54V, 2.50V,
2.48V, 2.46V, 2.43V, 2.40V, 2.38V, 2.35V, and 2.30V. The High level must be
greater than the Med level, and the Med level Must be greater than the Low
level. None of the levels can be equal to each other.
If it is selected, then the message most length is 2,000 characters, otherwise
only can 300 characters.
If "Direct" is selected then the message will show on the display at a message
received. Otherwise it only shows a message location icon on the display.
If it is selected, the message will show the address source at last.
It select the RF signal polarity is normal or invert.
If it is selected, duplication detection is performed on all personal messages
with the same message type as the new message, on a character by character
basis. Error characters are ignored during the check. If all non-error
characters in both messages match, the existing matching message is flagged
as a duplicate. The message with the least number of errors is stored and the
17
Advertisement
Table of Contents
