Honda CR85 2006 Owner's Manual page 43

Cooling System Inspection
1. Check the cooling system for leaks (see the
Honda Service Manual for troubleshooting of
leaks).
2. Check water hoses (1) for cracks,
deterioration, and clamp bands for looseness.
3. Check the radiator mount for looseness.
4. Make sure the overflow tube (2) is connected
and not clogged.
5. Check the radiator fins for clogging.
6. Check the water leakage check hole (3) below
the water pump for leakage. Make sure the
hole remains open. If water leaks through the
check hole, the water pump seal is damaged.
If oil leaks through the check hole, the
transmission oil seal is damaged. See the
Honda Service Manual or consult your Honda
dealer for replacing the water pump seal or
the transmission oil seal. Both seals should
be replaced at the same time.
(1)
(2)
(1) water hoses (3) water leakage check
(2) overflow tube hole
Coolant Replacement
Refer to Safety Precautions on page 19.
Coolant should be replaced by your Honda
dealer, unless you have the proper tools and
service data and are mechanically qualified.
Refer to the official Honda Service Manual.
(3) WARNING
Removing the radiator cap while the
engine is hot can allow the coolant to
spray out, seriously scalding you.
Always let the engine and radiator cool
down before removing the radiator cap.
To properly dispose of drained coolant, refer to
You & the Environment, page 102.
NOTICE
Improper disposal of drained fluids is harmful to
the environment.
Coolant
39
Servicing Your Honda