Advertisement
P7 201309003 KER755_K60-65.pdf 1C( K) ZB2319 2013.09.06
1005-001900
dtp
8.
The brewer will automatically fill the
4
fig.
internal tank with water and then the water
will be heated. This will take about 4 minutes.
During the heating period, the LCD Control
Center will indicate "NOT READY" (fig. 4).
not lift Handle during this heating period.
Once the water is heated, "READY TO BREW"
will be indicated and the Brew Buttons will be
illuminated (fig. 5).
NOTE: You may see small
amounts of water coming from the Vent and
dripping into the Water Reservoir during this
and subsequent heating — this is normal.
Lift and lower the Handle. Press the Small
9.
Mug Button to start a cleansing brew. When
5
fig.
the brew cycle is complete, pour the hot
water into the sink.
The one-time set-up process is now
10.
complete and you are ready to brew!
NOTE: The brewer may take 15 seconds
between brews and then "READY TO BREW"
will be indicated.
09
ctp
Do
7
ready to Brew Your First cup
6
fig.
1.
LCD Control Center will indicate
"READY TO BREW."
Place a cup or mug on the Drip Tray Plate.
2.
3.
Lift the Handle and the K-Cup
will open toward you (fig. 6).
Select a K-Cup
pack.
4.
®
NOTE: Do not remove the foil
lid or puncture the K-Cup
Place a K-Cup
pack in the
5.
®
K-Cup
Pack Holder (fig. 7).
®
CAUTION: There are two sharp needles that
puncture the K-Cup
pack, one above the
®
K-Cup
Pack Holder and the other in the bottom
®
7
fig.
of the K-Cup
Pack Holder. To avoid risk of
®
injury, do not put your fingers in the K-Cup
Pack Assembly Housing.
Lower the Handle to close the Lid over the
6.
K-Cup
Pack Holder. (When it is closed
®
completely, the LCD Control Center will
indicate "READY TO BREW" and the Small
Cup, Small Mug and Large Mug Buttons will
flash for up to 60 seconds.)
Pack Holder
®
pack.
®
®
Advertisement
