Advertisement
P6 201309003 KER755_K60-65.pdf 1C( K) ZB2319 2013.09.06
1005-001900
09
dtp
ctp
SECTION 1
Set-Up & First Brew
You cannot use your Keurig
IMPorTanT:
it has been set-up for its first use as set forth below.
If brewer has been exposed to temperatures
noTe:
below freezing, allow brewer at least two hours to
reach room temperature before brewing. A frozen
or extremely cold brewer will not operate.
Setting up Your Brewer
1
fig.
Unwrap cord and plug the brewer into
1.
a grounded outlet. Remove all pieces of
packing tape and clear plastic sticker
from LCD Control Center.
Place a large mug (10 oz. minimum) on the
2.
Drip Tray Plate.
Remove the Water Reservoir from brewer
3.
by first removing Lid from Reservoir (fig. 1),
then lifting Reservoir straight up and away
from brewer (may be tight), (fig. 2). Rinse
with fresh water.
brewer until
®
Lock Tabs
6
4.
Fill Water Reservoir with bottled or filtered
2
fig.
water so that the water is to and not beyond
the MAX FILL line.
Place Water Reservoir base into the left side
5.
of the brewer and be sure the Water Reservoir
Lock Tabs engage with the brewer (fig.2).
Replace Lid on Water Reservoir.
Press the Power Button found directly
6.
above the LCD Control Center (fig. 3).
The LCD Control Center will illuminate and
7.
indicate "NOT READY."
should not be used for this sequence
3
NOTE: If the Water Reservoir is empty or
fig.
not in place on the brewer, the LCD Control
Center will also indicate "ADD WATER." None
of the buttons will be activated until water
is added to the Water Reservoir and Water
Reservoir is in place.
NOTE: A K-Cup
pack
®
.
Advertisement
